Modelling: Chogoris County Choppers

[esinhorn]

Here is a tutorial on how I make my Choppers for my White Scars

 

1)Assemble chassis and wheels then cut off the front wheel

be careful to make it flush

http://i216.photobucket.com/albums/cc52/Esinhorn/CopyofPicture170.jpg

 

2)Use your hobby knife to make guide holes in the center where the spokes will go

then drill them out using a bit slighly larger than the rod you will use

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture162.jpg

 

3) Cut a notch behind the spokes on the chassis and using pliers bend them up

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture163.jpg

bent up, you only need to bring the spokes up a little bit to make the bike even

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture164.jpg

 

4) Take your plastic rod and cut two equal pieces about an 1" to 1" 1/4 long

you can also use the plastic protectors that come with a new paintbrush

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture165.jpg

 

5) Put plastic glue on the end of one side of the rods and insert them into the holes

made in the chassis spokes and let dry completely make sure they are even

and line up straight at this point

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture166.jpg

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture167.jpg

 

6) Then put glue on the other side of the spokes and put them into the hole you

made in the wheel spokes

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture168.jpg

 

7) Add handlebars,bottom and faring and you are done

http://i216.photobucket.com/albums/cc52/Esinhorn/Picture169.jpg

 

7a) You can skip this step if you want but I take a small amout of g/s and neaten

up where I cut and bent the spokes if you look close at the pic(7) you'll see

where I put grey stuff

[ZsaZsaRasputin]

Not as good without Mikey :( lol

 

Nice and simple job, nice one