Dark Angels Dreadnought help!

[LardO'Blood]

Ok, so I know the regular dreadnought arms don't fit the AoBR Dreadnoughts, how can I get around this without gluing the arms? I want it to stay modular. Also do the new venerable arms fit regular Dreadnoughts and vice versa?

[aekold]

Use magnets. I have done the same, so I can swap weapons between mij AobR dread and normal dread.

 

About the venerable dreadnought I have no idea if they will fit, but once again, use magnets.

[Tanhausen]

I have AoBR dreadnoughts... clipped the pivot, glued a magnet and another inside the weapon arm... works wonders.

 

So... get magnets xD

[CainTheHunter]

I have AoBR dreadnoughts... clipped the pivot, glued a magnet and another inside the weapon arm... works wonders.

 

So... get magnets xD

 

 

Another way is actually getting some plastic tubes, cutting them apart and putting them either on the AoBR dread or on the arms from "classic" dread - that way You can decrease/increase the diameters.

[chromedog]

I magnetise the arms and leave the pivot stump on right where it is.

 

I glue a steel washer AROUND it.

 

Magnet grabs washer, pivot point stops it sliding off.