Warbringer Posted October 1, 2012 Share Posted October 1, 2012 Hey Brothers (and Sisters) I'm magnetising my compemptor dread, i've completed all the arms but am slightly at a loss on how to magnetise the cyclone missle launcher without loosing detail? Anyone done this or have any good ideas? Link to comment https://bolterandchainsword.com/topic/262144-contemptor-dreadnought-magnetising-help/ Share on other sites More sharing options...
Grotsmasha Posted October 1, 2012 Share Posted October 1, 2012 As in, have it posable or removable? Either way, the answer is smaller magnets. As far as saving detail goes, you could sink the magnets on the torso a little deeper (0.5 to 1mm) than normal and smooth over the gap with green stuff. Cheers, Jono Link to comment https://bolterandchainsword.com/topic/262144-contemptor-dreadnought-magnetising-help/#findComment-3192915 Share on other sites More sharing options...
Warbringer Posted October 1, 2012 Author Share Posted October 1, 2012 Yeah i've got some small magets which i'll try and stick them in with. Yeah i suppose its only £30 if i totally bugger it up :D Link to comment https://bolterandchainsword.com/topic/262144-contemptor-dreadnought-magnetising-help/#findComment-3192934 Share on other sites More sharing options...
Haranin Posted October 1, 2012 Share Posted October 1, 2012 Any chance of pictures? Eying the same project in a few months... Link to comment https://bolterandchainsword.com/topic/262144-contemptor-dreadnought-magnetising-help/#findComment-3192949 Share on other sites More sharing options...
Warbringer Posted October 2, 2012 Author Share Posted October 2, 2012 Will take some tonight of the plan and will post them. Link to comment https://bolterandchainsword.com/topic/262144-contemptor-dreadnought-magnetising-help/#findComment-3193515 Share on other sites More sharing options...
Ironblood Posted October 2, 2012 Share Posted October 2, 2012 try drilling a hole and setting the magnets in, then put a very thin layer of contour putty (green stuff and or miliput would work as well) over the magnets and sand /file it flush, and do the same with the launcher. Unless you sink the magnets REALLY deep it should hold just fine. Link to comment https://bolterandchainsword.com/topic/262144-contemptor-dreadnought-magnetising-help/#findComment-3194169 Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.