Can anyone recommend a pin vise/drill?

[nismogrendel]

I've been using the citadel drill, but it is starting to fail me.  It came with 3 bits, the middle sized bit is having problems.  I think the issue is with the chuck.  When I screw the drill together, the bit will slip inside the chuck.  If I press hard enough the bit falls down inside the chuck.

 

I think I wore the teeth down on the chuck over time. 

 

It still works fine for the size 1 and size 3 bits.

 

I'm looking at a few different drills on amazon... not sure which one to go with.

 

These two look not bad:

 

http://www.amazon.com/General-Tools-Instruments-93-Adjustable/dp/B000COYPG4/ref=pd_cp_469_4?ie=UTF8&refRID=11DYK8TY8Q788HVHXTX8&dpID=31NFUAjUjKL&dpSrc=sims&preST=_AC_UL70_SR70%2C17_

http://www.amazon.com/General-Tools-Instruments-S94-Single/dp/B001HWA8UW/ref=sr_1_1?srs=9391149011&ie=UTF8&qid=1445527016&sr=8-1&keywords=s94

 

Any suggestions?

[Bung]

Try to get the one from Gale Force  with the wood end, its pretty good.

[CommodusXIII]

I have an old Citadel pin vise that I picked up in 2001 that's outlasted set after set of bits. Like the Adeptus Mechanicus, they don't build anything like they used to.

[Lucien Eilam]

Yeah, I'm a big fan of the old Citadel one too. It was a third-party product just repackaged, and it's still available under various names from many retailers. The Army Painter "Miniature and Model Drill" is one example, IIRC.