Search the Community
Showing results for tags 'Resin'.
Found 3 results
-
WarCom Article. Back to our regularly scheduled programming.
-
I recently got my first Forgeworld kit, and I noticed something odd while I was cleaning the pieces. I was rinsing the model for the final time and I had them in a container of water. I saw there were tiny bubbles on the parts. They were all a uniform size, but I couldnt tell if it was bubbles of air or bubbles of water (while submerged in water). The process I took to wash the parts: 1) I first let them soak for a few minutes submerged in 91% Isopropyl. 2) I then scrubbed each piece thoroughly with a soft toothbrush. 3) Rinsed with tap water 4) I let them soak for about 10 minutes in a small tub of hot water with Dawn (plain) soap. 5) parts were again scrubbed with a soft Toothbrush in the soapy water. 6) Rinsed with Tap water multiple times. It was during the final rinsings that I noticed the bubbles. I probably rinsed the parts 4 or 5 times, and each time, they would have these bubbles. I'm kind of out of my league at this point and could use some advice. -
Greetings Fellow Brothers! I bought a set of Deimos Rhinos from FW to round up my Legions. The kits are fine, but unfortunately the majority of the resin hull elements are bent. On one-two it is almost indiscernible, but others look really bad. I would ask for your help and advice. I worked with resin before, but they where only infantry models, with nearly no warping. But these fault really annoy me. Is a hairdryer and some cold water enought to bent them back a little bit? Or is there more finesse needed?
