DreamWeaver Posted September 23, 2011 Share Posted September 23, 2011 Alrighty, so I've been trying to scratchbuilt alot of stuff with plasticard lately, and I can't figure out how to construct things at 45 and 90 degree angles and such, whenever I try to build at an angle it usually is extremely weak or not precise. Was wondering if anyone had any special techniques they used to ensure a good angle and sharp corners etc. Also, does the technique etc. vary depending on the thickness of the plasticard? Thanks! Link to comment https://bolterandchainsword.com/topic/238983-angles-with-plasticard/ Share on other sites More sharing options...
adeptuscustodus Posted September 23, 2011 Share Posted September 23, 2011 What I always do is when I cut the parts out is to make sure one parts overlaps the other by about 0.5mm and then sand it down with gradually finer emeryboards to get a perfect sharp edge Link to comment https://bolterandchainsword.com/topic/238983-angles-with-plasticard/#findComment-2883453 Share on other sites More sharing options...
Olgerth Istaarn Posted September 23, 2011 Share Posted September 23, 2011 Cut two separate surfaces. Angle them as you wish and attach them together with the green stuff (just slap a blob of it on the side that will be hidden from view). While the green stuff is malleable, you can adjust the angle until you get it right. Let dry. Throw some superglue on there for good measure if desired. Slather a liberal amount of sandable putty on the visible side. Sand with progressively fine emery boards until desirable finish is achieved. Link to comment https://bolterandchainsword.com/topic/238983-angles-with-plasticard/#findComment-2883496 Share on other sites More sharing options...
DarKHaZZ13 Posted September 23, 2011 Share Posted September 23, 2011 Buy a protractor/set square? Should solve your precision problems Link to comment https://bolterandchainsword.com/topic/238983-angles-with-plasticard/#findComment-2883498 Share on other sites More sharing options...
Gurth Posted September 23, 2011 Share Posted September 23, 2011 Do you bevel the edges of the panels before you glue them? If not, you may want to start doing that :) Link to comment https://bolterandchainsword.com/topic/238983-angles-with-plasticard/#findComment-2883577 Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.